(1999-2004) New Edge Mustang V6 & V8 GT Tech

3DMach1 · #1 05-28-2011, 06:53 PM

I wanted to know it Mach 1 factory brakes caliper & rotors which I believe are just regular GTs would fit on an 02 V6 ?

**PWRBY4D** · #2 05-28-2011, 08:13 PM

wheel clearance may be an issue... other than that i think it should swap over fine.

3DMach1 · #3 05-28-2011, 10:07 PM

swapping the wheels also so i think ill be good

**Stangman Jonathan** · #4 05-28-2011, 10:48 PM

I agree you shouldn't have a problem, best way would be to test one out if you can. I can tell you about being the one with rubbing wheels/calipers with wheels in the past lol

**GT800** · #5 05-29-2011, 01:04 AM

na everything should bolt up

blown5.0 · #6 05-29-2011, 05:51 AM

it will bolt up, you will need the calipers, caliper brackets, pads, and rotors.

slvrgt · #7 05-29-2011, 04:56 PM

they will fit. they r not GT size, mach 1' r the same as cobra's and bullitt's the only difference between the 3 is cobras say cobra on the caliper, the bullitt has a running horse, mach's r blank. they r 13 inch rotors so u need a 17" or bigger rim.

hpwrestler220 · #8 05-31-2011, 09:25 PM

I agree ^^

They are all 38mm pistons besides i think the 03/04 cobra calipers. But basically, they are all the same thing (Bullitt, mach, cobra)

You will need 17" wheels or bigger like stated above.

Brackets, pads, calipers, rotors. 30 minute job... Just make sure you get the brackets!!! Those suckers will be so expensive if not..

IT'S A DIRECT SWAP