Downs Ford Motorsport - Toms River NJ Ford Dealership - Route 37 Ford

3DMach1 · #1 03-09-2010, 11:03 PM

who do we know down in Downs Ford on route 37? I know it's a well known ocean county Ford Dealership in Toms River NJ? im heading down there Thursday morning to have my stang checked out. Just wanted to know if there was anyone who would help me out more than somebody else.

**Stangman Jonathan** · #2 03-09-2010, 11:06 PM

Rick is the Downs Ford Racing Guy and Jimmy in Service is your Mustang Expert! Just tell them your part of our family and they will take care of you! I'm going down tomorrow get my F150.

3DMach1 · #3 03-09-2010, 11:11 PM

o0o nice, thanks jon

infamousjim · #4 03-09-2010, 11:16 PM

do they do alignments there? I've been getting dicked around by my old guy and the car is still pulling so I'm looking into new places.

#5 03-09-2010, 11:19 PM

Yea they did my four wheel alignment for $90 after my suspension stuff. Jon you will be there tomorrow?

3DMach1 · #6 03-09-2010, 11:22 PM

Quote:

Originally Posted by infamousjim

do they do alignments there? I've been getting dicked around by my old guy and the car is still pulling so I'm looking into new places.

what do you mean by pulling exactly?

#7 03-09-2010, 11:25 PM

maybe he means to one side?

infamousjim · #8 03-09-2010, 11:34 PM

hmm, how are they for performance specs? the other thing that made me angry was my last shop stopped doing as i requested and would only do camber to "Factory spec" and wouldn't give me any more

car pulls left bad enough to climb the curve of the road. I've done damn near everything in the whole "my car pulls" playbook....
i've already...
swapped tires side to side
checked pressure over and over
two new lower control arms
balljoints checked fine
torqued, retorqued, and loctited suspension
replaced a bad caliper, others are okay.

koni sports on factory springs.

only thing left that I found, when i measured hub to hub the right side was 1/4" longer than the left. Also when i measured the rear hubs to fender, it was the same 1/4" so it seems the rear is 1/4" crooked. I'm not sure if that would be enough to make the car pull, but the last shop didn't mention anything about that.